弊社が提供した部分の資料を試用してから、決断を下ろしてください。もし弊社を選ばれば、１００％の合格率を保証でございます。
Citrixの1Y0-A28認定試験を受験する気があるのですか。この試験を受けた身の回りの人がきっと多くいるでしょう。これは非常に大切な試験で、試験に合格して1Y0-A28認証資格を取ると、あなたは多くのメリットを得られますから。では、他の人を頼んで試験に合格する対策を教えてもらったのですか。試験に準備する方法が色々ありますが、最も高効率なのは、きっと良いツールを利用することですね。ところで、あなたにとってどんなツールが良いと言えるのですか。もちろんJPexamの1Y0-A28問題集です。
1Y0-A28はCitrixの一つ認証試験として、もしCitrix認証試験に合格してIT業界にとても人気があってので、ますます多くの人が1Y0-A28試験に申し込んで、1Y0-A28試験は簡単ではなくて、時間とエネルギーがかかって用意しなければなりません。
JPexamにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCitrix 1Y0-A28認証試験に参加する方に対して問題集を研究続けています。君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにJPexamを選択してください。JPexamはまた一年間に無料なサービスを更新いたします。
試験番号：1Y0-A28問題集
試験科目：Implementing NetScaler 10 for Networking and Traffic Optimization
最近更新時間：2014-01-03
問題と解答：全123問
100％の返金保証。1年間の無料アップデート。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.jpexam.com/1Y0-A28_exam.html
NO.1 An engineer has two NetScaler devices in two different datacenters and wants to create a high
availability (HA) pair with the two devices, even though they are on two different subnets.
How can the engineer configure the HA Pair between the two NetScaler devices?
A. Configure StaySecondary on the second datacenter appliance.
B. Ensure that INC mode is enabled during the creation of the HA Pair.
C. Enable the HAMonitors on all interfaces after the HA Pair has been created.
D. Change the NSIP of the second appliance to be on the same subnet as the first appliance.
Answer: B
Citrix過去問 1Y0-A28 1Y0-A28 1Y0-A28 1Y0-A28 1Y0-A28
NO.2 Scenario: The NetScaler has connections to a large number of VPNs. The network engineer
wants to minimize
the number of ARP requests. Which feature should the network engineer enable to minimize ARP
requests?
A. TCP Buffering
B. Use Source IP
C. Edge Configuration
D. MAC based forwarding
Answer: D
Citrix参考書 1Y0-A28問題集 1Y0-A28過去問 1Y0-A28
NO.3 The network engineer would like all HTTP and HTTPS requests that travel through the
NetScaler to have an HTTP header added with the source IP address for logging on the web servers.
How should the network engineer accomplish this?
A. Enable Web Logging
B. Enable the client IP option
C. Configure the TCP Parameters
D. Enable the 'Use Source IP mode'
Answer: B
Citrix 1Y0-A28認定試験 1Y0-A28参考書 1Y0-A28 1Y0-A28
6. A network engineer has configured two NetScaler MPX appliances as a high availability (HA)
pair.
What can the engineer configure to prevent failover if only a single interface fails?
A. FIS
B. PBR
C. SNMP
D. VMAC
Answer: A
Citrix 1Y0-A28 1Y0-A28認証試験 1Y0-A28 1Y0-A28認証試験
7. Scenario: A NetScaler appliance currently has a manually configured channel containing four
interfaces;
however, the engineer has been told that the NetScaler must now only use a single interface for this
network.
The engineer removes the channel and immediately notices a decrease in network performance.
How could the engineer resolve this issue?
A. Reset the unused interfaces
B. Disable the unused interfaces
C. Enable flow control on all interfaces
D. Disable HA monitoring on the three interfaces that are no longer required
Answer: B
Citrix 1Y0-A28 1Y0-A28
8. Scenario: A NetScaler engineer needs to enable access to some web servers running on an
IPv6-only network. The clients connecting
the services are
on an IPv4 network. The
engineer has already enabled IPv6 on the NetScaler. What does the engineer need to do in order to
provide access to the services on the IPv6 network?
A. Create an IPv6 tunnel and a IPv4 virtual server.
B. Configure an IPv6 VLAN and bind the required interface.
C. Create a IPv4 virtual server and bind the service group to it.
D. Create an IPv6 ACL and a IPv4 virtual server and bind the ACL to the virtual server.
Answer: C
Citrix参考書 1Y0-A28問題集 1Y0-A28 1Y0-A28認定証
9. Scenario: An engineer executes the following commands: add vlan 2 bind vlan 2 -ifnum 1 / 2 add
ns ip 10.110.4.200 255.255.255.0 bind vlan 2 -IPAddress 10.110.4.200 255.255.255.0 What type of
IP address has been added to the NetScaler?
A. VIP address
B. NSIP address
C. SNIP address
D. GSLB Site IP address
Answer: C
Citrix 1Y0-A28 1Y0-A28認証試験 1Y0-A28認定資格
10. Scenario: A network engineer needs to configure Citrix NetScaler to provide Access Gateway
services to VLAN 2 using interface 1 /1 only, while also using interface 1 / 2 to provide load balancing
services to VLAN 3. How could this result be achieved?
A. Disable static route advertisement.
B. Disable layer 2 mode Create 2 untagged VLANs - VLAN 2 and VLAN 3 Bind VLAN 2 to Interface 1 /1
Bind VLAN 3 to Interface 1 / 2
C. Enable Layer 3 mode Create a Channel Interface using Interface 1 /1 and 1 / 2 Create 2 VMACs Bind
a VMAC to interface 1 /1 and 1 / 2
D. Configure policy-based routing using the Interface option as a filter.
Answer: B
Citrix認定試験 1Y0-A28認定資格 1Y0-A28 1Y0-A28認定証
11. Scenario: A network engineer needs to re-configure the NetScaler to utilize two new VLANs -
VLAN2 and VLAN3. VLAN2 is an untagged VLAN and VLAN3 will require a .1q compliant tag.
Interface 1 /1 is the only interface that
will be used on the NetScaler. How could the engineer configure
the NetScaler so that it can communicate with both networks?
A. Change the NSVLAN to 3 Add VLAN 2 and bind interface 1 /1 as untagged
B. Enable the Tag all VLANs option on interface 1 /1.
C. Add VLAN2 and bind interface 1 /1 as untagged Add VLAN3 and bind interface 1 /1 as tagged
D. Add a SNIP for each VLAN Enable management access on the SNIP for VLAN3
Answer: C
Citrix参考書 1Y0-A28認定資格 1Y0-A28問題集 1Y0-A28
12. Why would an engineer want to specify a TCP Profile for a specific service group?
A. To enable use of features like SSL over TCP for that specific service group.
B. To adjust the TCP settings for traffic to and from that specific service group.
C. To use a specific SNIP for traffic to the back-end servers in that service group.
D. To enable features like use source IP , TCP keep alive and TCP buffering for a specific service group.
Answer: B
Citrix 1Y0-A28問題集 1Y0-A28 1Y0-A28認定試験
NO.4 A network engineer needs to upgrade both appliances of a High Availability (HA)
pair. In which order should the network engineer upgrade the appliances?
A. Disable high availability and upgrade one node at a time.
B. Upgrade the primary node first without disabling high availability.
C. Upgrade the secondary node first without disabling high availability.
D. Perform the upgrade simultaneously without disabling high availability.
Answer: C
Citrix認定証 1Y0-A28 1Y0-A28問題集 1Y0-A28問題集 1Y0-A28
NO.5 What should a network engineer do to prevent unauthorized users from using the root user
account?
A. Reset the nsroot account.
B. Change the nsroot password.
C. Create an authorization policy.
D. Bind a policy to the root user account.
Answer: B
Citrix 1Y0-A28認定資格 1Y0-A28過去問 1Y0-A28
JPexamは最新のCD0-001問題集と高品質のMSC-331問題と回答を提供します。JPexamのHP2-E58 VCEテストエンジンとHP3-C33試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質のFCNSA.v5 PDFトレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100％保証します。試験に合格して認証資格を取るのはそのような簡単なことです。
没有评论:
发表评论